It’s been nearly a month since I started the unavoidable demolition and remodeling of our guest bathroom, which had been brought on by a water leak in the wall. The plumbing has been fixed, the walls have been put back up, the new fixtures are mostly installed, and finally – last night – we put the new Toto Aquia II dual flush toilet in. In a house that currently has 5 people and only 1 toilet, this was a BIG deal. We were all fighting to be the first to use it.
It was surprisingly easy to install, considering there are lots of complaints in various forums about how hard it is to get it to seal properly to the flange which can cause it to leak. I even read replies from plumbers on some forums who say they charge double to install these toilets. We didn’t have any trouble at all.
My wife was the first to have the honor of using it, while we waited patiently outside the door with anticipation of her review of the experience. A resounding thumbs up from her.
I’ll update with pictures and a bit more of an in depth review after it’s been tested a little more thoroughtly. For now, though, we did notice that the dual flushing mechanism is going to be something we’ll need to get used to. For the light flush, if we just push and release the button then there isn’t much water released into the bowl. If we hold the button down then it will release all of the water into the bowl – all 1.6 litres of it. We must be doing something wrong, but again, I’ll give a better review after the break-in period is complete.